CRAFTSMANSHIP
Craft & acceptance standards
We break high-end into 19 checkable items. These standards go into the contract so you can verify them one by one before installation.
DESIGN
Design standards
Proportions, modules and layout are fixed at drawing stage, so nothing is left to guesswork on site.
01
Proportion aesthetics
Golden ratio 0.618 / symmetrical division / 3:4:3 tripartite — choose by style
02
Gap standards
3 mm minimal (S1/S3) / 4 mm shaped doors (S2/S4), tolerance ±0.5 mm
03
All visible faces reviewed
Side panels, shelf fronts and back-panel edges veneered in the same material as the doors
04
Plan lighting up front
Cut-outs go straight from the order to the workshop — zero on-site cutting; 3000 K throughout
05
Full-height doors
Top filler ≤40 mm; skirting 60–100 mm; separate doors for stacked units
06
Series consistency
S1 minimal profiles; French as full sets; veneer laid out in advance; solid wood color untouched
HARDWARE
Hardware standards
Hardware is where the experience comes from; brands, models and quantities are written into the contract.
01
H ≤ 900mm
80 mm from the top edge to the ceiling and 80 mm from the bottom edge to the floor
Number of hinges
02
900 < H ≤ 1600
One centred in the middle
Number of hinges
03
1600 < H ≤ 2100
Even spacing within 2 mm
Number of hinges
04
H > 2100mm
Straightening bar required
Number of hinges
05
550/600 mm (wardrobe)
Runner options
06
450 mm (bookcase)
Runner options
07
350 mm (slim cabinet)
Runner options
ACCEPT
Acceptance standards
Measurable acceptance steps to work through one by one after installation.
01
Door gaps
Feeler-gauge check over the full height
5-year warranty
02
Hinge operation
Open and close 20 times in a row
10-year hardware warranty
03
Drawer operation
Pull out fully loaded 20 times
10-year hardware warranty
04
Handles secure
Hand pressure plus spirit level
5-year warranty
05
LED lighting
Full lighting test
3-year warranty
06
Functional parts
Tested item by item
5-year warranty
CHECKLIST
How installation acceptance works
We suggest checking the four steps below on site, marking any issue immediately rather than raising it after moving in.
- 01
Check the elevations
Whether gaps are even and flush, whether the cabinet meets the wall in a straight line, and whether exposed panels vary in colour.
- 02
Hands-on opening and closing
All drawers and doors move smoothly with damping engaged and no noise; lift-up and corner mechanisms return correctly.
- 03
Check the edge banding
Board edges fully banded with no chipping, a fine glue line with no squeeze-out, and countertop joints barely visible.
- 04
Checklist
Check hardware brands and quantities item by item against the contract, and ask for warranty cards and eco test reports.
CRAFTSMANSHIP
Want to know how these standards apply in your home?
Leave your floor plan and contact details; a design consultant will reach out within 24 hours with free layout advice and an initial quote.
- · Free measurement · Free 3D design · Free quote
- · Factory-direct, no middleman markup
- · ENF-grade eco substrate, move in right after install
- · Four series, freely mixable in one design language
Hotline 133-4035-1791